Wind the recoil starter, within the starter housing, counter-clockwise around 6 or 7 times until you feel resistance. Next, grab a screwdriver and keep it close. To remove the old pull cord, cut the end of the cord to remove the knot that holds it within the starter housing, then pull it through the handle and discard it. If you are just replacing the pull cord, move on to the next step. If you are installing a new housing with a pull cord already tensioned, you can skip to Step 11. Loosen the guide loop that holds the starter handle in place using the thumbscrew. Remove the bolts holding the starter and blower housing to the frame. Step 7: Remove The Starter and Blower Housing.Once you have removed the screws, elevator the housing and fuel tank off the machine and place them aside. Where they are located depends on the hipotetis, but they should be easy enough to find. To remove the housing, locate the screws that hold it in place. Clamp the line, then release the connected logam clamp and pull the line off the engine. Locate the fuel line running from the fuel tank to the engine. Locate the primer bulb and pull off the connected rubber tube. Release it by pressing the tab and pulling it out. Under the safety ignition key slot, you will find an attached wire caddy.
0 Comments
Leave a Reply. |